[. . . ] You can be killed or seriously injured if you don't immediately follow instructions. You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. [. . . ] The shipping feet will protect the lower oven trim until the oven is inserted into cabinet. Locate the oven door latches in both corners of the oven door, and rotate the latches forward to the unlocked position. To properly install your oven, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. Oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model/serial number rating plate is located at the bottom of the right-hand mounting rail. Flexible cable from the oven should be connected directly to the junction box. Grasp the edges of the oven door with both hands and close the oven door until it will no longer close. If your home has: 4-wire Go to section: 4-wire Cable from Home Power Supply Side trims must be removed before unit is installed in the cabinet. Where local codes do not allow grounding through neutral, New Branch circuit installations (1996 NEC), mobile homes and recreational vehicles, new construction and in Canada. Failure to follow these instructions can result in death, fire, or electrical shock. This oven is manufactured with a neutral (white) power supply wire and a cabinet-connected green (or bare) ground wire twisted together. Feed the flexible cable conduit from the oven through the opening in the cabinet. Untwist white wire from green (or bare) ground wire coming from the oven. Connect the 2 white wires (F) together using a UL listed wire connector. [. . . ] Use the 8-18 x ³/" flathead screws, located in the screw bag assembly, to attach each trim piece to oven. Replace oven door by inserting ends of hinges into hinge slots in the oven frame. Display panel will light briefly, and "PF" should appear in the display. [. . . ]